For U Solution

The fuel filter on a 1985 Buick Century is designed so that gasoline flowing to the engine is free of harmful debris. The fuel pump, located inside the gas tank, has a built-in strainer. This keeps large debris from leaving the tank but smaller debris and sediment can get past the strainer. If not changed, the small debris will eventually clog the fuel filter; this can affect gas mileage and engine performance. Fuel filters should be changed annually or every 30,000 miles.

Instructions

Remove the Fuel Filter

1

Open the hood and locate the fuse panel. Open the fuse panel and locate the fuel pump relay. Pull it out by hand.

2

Start the engine and let it run. The engine will stall once the fuel system has depressurized. Turn off the engine and replace the relay back in to the fuse panel. Close the fuel panel.

3

Crawl under the car behind the driver-side rear wheel well and look for the fuel filter. The fuel filter is canister-shaped with a fuel line entering and exiting the filter; it will be in a mounting bracket on the frame rail. You can also trace the fuel line from the gas tank to find the fuel filter.

4

Place a drain pan under the fuel filter to catch any gas in the fuel lines or the fuel filter.

5

Disconnect the inlet fuel line from the fuel filter by pinching the tab on the quick-disconnect fitting and pull the fuel line off the fuel filter. If the fuel line is held on by a hose clamp, loosen the clamp with a screwdriver. Remove the outlet fuel line the same way.

6

Use a socket wrench to loosen the bolt on the mounting bracket and slide the fuel filter out of the bracket. Discard the fuel filter.

Install the Fuel Filter

7

Slide the new filter in the bracket. Make sure the arrow on the fuel filter is pointing toward the front of the car. The arrow designates the direction of fuel flow. Tighten the bracket bolt with the socket wrench. The fuel filter should be tight in the bracket.

8

Push the inlet fuel line onto the fuel filter until it clicks in place. If held on by hose clamps, push the fuel line over the fitting on the fuel filter. Slide the hose clamp over the hose and fitting and tighten it with a screw driver. Do the same for the outlet fuel line.

9

Start the engine and let it to run for at least 5 minutes.

10

Check the fuel filter and fuel lines to make sure there are no gas leaks.

To access a 2005 Toyota Camrys oil filter, lift or jack up the vehicle. The oil filter is located toward the front of the vehicle, next to the oil pan.

Safety Issues

Any time you are going to remove or replace an oil filter, wear safety glasses and gloves. Even if you wont be changing the oil itself, removing the filter involves possible contact with engine oil. Never attempt to remove an oil filter while the 2005 Camrys engine is running. Depending on the brand of filter, you may need an oil removal wrench.

Removal

Before removing the filter, place an oil drip pan directly beneath it. Slowly unscrew the filter to allow oil to drain out. Then unscrew the filter, but be careful of the oil within the filter. Dump this oil into the drip pan. Look at the filter and ensure the gasket is not stuck to the mounting base. With a clean shop towel, wipe the mounting base clean.

Replacement

Apply a film of clean engine oil to the new filters gasket, which helps create a seal between the gasket and the mounting base. Screw the new filter into place, but do not overtighten and potentially strip the mounting base.

Two Different Sizes

Before replacing the 2005 Camrys oil filter, ensure that you have bought the right size filter. A 2005 Camry with a four-cylinder engine requires a different size filter than a six-cylinder engine. There are no universal sizes for oil filters, and manufacturers feature different part numbers.