Friday, November 29, 2013

How to Make an Accel Spark

Spark plugs are essential for your engine to run properly. If you are having problems with your spark plugs, you dont necessarily have to replace them; you can replace the Accel spark plug wires. This costs less than replacing your spark plugs, but you have to size them properly to your spark plug. You dont have to be a mechanic to replace the wires. You can do it yourself.

Instructions

    1

    Use your spark plug boot to remove the spark plug from the engine. The spark plug is labeled and located on the side of the engine.

    2

    Pull your wire through the looms until you have access to the distributor cap.

    3

    Put a mark on the wire about 3 inches from the distributor cap with your permanent marker. Use your wire cutters to cut the wire.

    4

    Use the wire cutters to strip the wires about five-eighths of an inch from the spark plug wire and your replacement wire. Use wire nuts to connect the replacement wire with the existing wire.

    5

    Crimp the wire nut to make sure the wire nut stays secure. Push the new wire into the distributor cap to complete the installation.


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.