Sunday, December 15, 2013

My Dodge Engine Light Wont Go Out

My Dodge Engine Light Wont Go Out

You need to reset the check engine light on your Dodge after you have had regular service or after youve replaced an electronic component that caused the light to go on. In addition, the computer code needs to be cleared so that it can function properly.

Instructions

    1

    Locate the fuse panel cover on your Dodge. This is located on the dash under or near the steering column. Pull down on the panel using your fingers.

    2

    Look for the port within the fuse panel that looks like it will fit the connector end of your diagnostic reset tool. This tool can be purchased from your local auto parts retailer.

    3

    Plug the connector into the port.

    4

    Put the key into the ignition and turn it to the "II" position. Wait for the blinking light on the reset tool to turn off. Look on the instrument panel of the Dodge to see that the engine light has turned off as well.


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.