For U Solution

Adjust the emergency brake on your Mustang right from your home garage and save money. You can adjust it from inside the car so you dont have to get yourself dirty by working under the car. Is time to adjust the parking brake when you park downhill and the parking brake starts to slip. This means that the parking brake cable has slackened inside the cable rod and needs to be tightened with the adjuster nut. Tension put on the emergency brake over time causes the parking brake to slip.

Instructions

1

Locate the parking brake in the front center of the inside of the vehicle. Remove the console cover that houses it.

2

Lift up the emergency brake lever four notches.

3

Look for the parking brake cable rod. On this rod is an adjuster nut. Turn that nut with the pliers until it is loose but make sure it doesnt fall off all the way.

4

Release the parking brake and tighten the nut.

5

Raise and lower the emergency brake lever four times. This will set the adjustment of the parking brake.

6

Park the Mustang on a downhill slant and engage the parking brake only. It should hold the vehicle in place. If it doesnt, repeat the adjustment.

You can adjust the parking brake on your Chevy Lumina right from your home garage, saving yourself time and money. The parking brake can be adjusted from inside the vehicles center console. You just need a couple of tools from your local auto parts retailer and about a half hour of time to get the job done. You will know its time to adjust the parking brake if your vehicle starts to move while parked on a downhill slope with the parking brake set.

Accessing the Parking Brake Cable

Release the parking brake lever. Locate the two screws on either side of the center console cover between the driver and front passengers seats. Pull up on the release lever and remove the screws on the console with a screwdriver. Pull straight up on the console cover to remove it.

Adjusting the Parking Brake Cable

Locate the two nuts on the parking brake cable. Turn the nuts in a clockwise direction with a wrench to tighten the cable. This adjusts the parking brake.

Finishing Up

Put the console cover back into place and tighten the screws with the screwdriver. Pull up on the parking brake lever. It should pull up a maximum of six clicks or less.

The C5 Corvette encompasses the 1997 through 2004 model years. All of the C5 models are equipped with four-wheel disc brakes. Removal of a rear rotor is required forits replacement or when you need to work on the rear hub assembly. Warping, cracking or structural failure may necessitate brake rotor replacement. Brake pads wear the rotor over time, requiring their replacement when the rotor thickness no longer meets minimal standards.

Instructions

1

Place wheel chocks behind and in front of the front wheels to secure the vehicle. Loosen the lug nuts on the rear wheel one turn with the breaker bar and socket.

2

Raise the rear of the Corvette using the floor jack and secure with a jack stand on each side of the automobile.

3

Remove the five lug nuts using a ratchet and socket. Pull the wheel away from the hub assembly and store the wheel in a safe location.

4

Use a 22 mm socket and ratchet to remove the two bolts securing the caliper bracket to the rear hub assembly.

5

Slide the caliper assembly off the rotor and use a short length of bailing wire to hang the assembly in the wheel well. This will prevent damage to the hydraulic hose attached to the caliper.

6

Use both hands to pull the rotor away from the vehicle until it is clear of the wheel studs.

You can make an adjustment to the parking brake on your GMC Safari right from your home garage, saving yourself time and money. The way you can tell that its time to adjust your Safaris parking brake is when you park downhill and set the parking brake but it starts to slip. The best part is that the job doesnt take long and you dont even need any tools.

Instructions

1

Locate the parking brake pedal on the left side of the drivers foot well. Press down on the pedal all the way to the floor as far as it will go.

2

Disengage the parking brake pedal by pressing down on it again with your foot.

3

Repeat Steps 1 and 2 at least three more times to adjust your Safaris parking brake. This automatic adjustment takes up the slack in the parking brake cable.

4

Park your vehicle facing downhill. Engage the parking brake. You will know you have correctly adjusted the parking brake if your Safari holds in place and doesnt slip.