For U Solution

How to Lower a Motorcycle With Shock Absorbers Without Springs

The shock absorber springs on a motorcycle have nothing to do with lowering the seat height, which is what riders are usually trying to accomplish by lowering the rear end. Some motorcycle shock absorbers have visible springs encasing the damper tubes, and some have only damper tubes. Whatever the brand, model or year of your motorcycle, it came with shock absorbers that are exactly the length your bikes manufacturer recommends. And, regardless of the bike, shock absorbers sold as "under standard length" in 1/2-inch increments are readily available. Just install a set of shock absorbers that are 1 inch under standard length.

Instructions

1

Raise the motorcycle to be fully upright and level by either placing the front wheel of the bike in a motorcycle chock, clamping the front wheel in a motorcycle vise on a motorcycle lift, or slightly raising the bike on a motorcycle jack.

2

Remove the lower then the upper shock absorber mounting bolts on the right-side shock, using a standard or metric hex socket, Torx socket or Allen socket and a socket wrench. The socket you will use depends on the manufacturer, model and year of your motorcycle.

3

Remove the right-side shock absorber. Unfasten the same four bolts on the left side of the motorcycle and remove the left shock absorber.

4

Clean the bolts, nuts and washers you remove with a rag and light oil. Apply a few drops of thread locker to the old bolts.

5

Replace the old shock absorbers with new, shorter shock absorbers on both sides of the motorcycle using the old bolts, washers and nuts.

6

Remove the bike from the chock, motorcycle vise or motorcycle jack.

7

Sit in the saddle. Bounce up and down. Ensure the shocks work properly.

Posted by Unknown at 3:15 AM

Email ThisBlogThis!Share to XShare to Facebook

Labels: a, absorbers, how, lower, motorcycle, shock, springs, to, with, without