For U Solution

How to Replace a Water Pump for a 1998 Chevrolet Monte Carlo

Its not difficult to replace the pump for a 1998 Chevrolet Monte Carlo. In fact, replacing a pump should a priority since a deteriorating pump is generally the root of poor fuel economy and lackluster vehicle performance. The Monte Carlos engine wont even operate if the pump isnt working. The pump located inside the 1998 Chevrolet Monte Carlo is accessed through a panel in the trunk.

Instructions

1

Use the socket wrench to remove and take out the fuel pump relay. Its attached on the engine compartments right side near the fuse panel. Turn on the engine. Let it run until it stops so that the fuel pressure will be relieved.

2

Take out the trunk liner. Remove the cars spare tire. Youll now see the cars access panel which will allow you to access the pump. Take of the bolts which hold the pump in place. Take off the panel.

3

Inspect the pump assembly. Clean out any dirt or debris from around it. Unsnap the fittings which keep the lines in their place. Disconnect the electrical connector. Unlatch and remove the large ring which holds the pump assembly.

4

Take off the pump assembly. Replace it with the new one. Put the latch back into its original place. Carefully plug the electrical connector back in. Put the spare tire back in and reinstall the access panel.

Posted by Unknown at 8:45 AM

Email ThisBlogThis!Share to XShare to Facebook

Labels: 1998, a, carlo, chevrolet, for, how, monte, pump, replace, to, water